1. DRL 100% And Rear LEDs
Device 09-central electronics> coding> byte 11, bit 2
The green indicator light on the light switch stays lit all the time when the DRL is. Also the map display in navigation mode is dimmed for night usage all the time.
2. Fog Turn Lights
Enables fog cornering lights.
Control unit “09-Central Electric”>> “Encoding”>> Byte 14, Bit 7
Settings: 0 / 1
Default: 0
3. Disable Headlight Washers
Control unit “09-Central Electric”>> “Encoding”>> Byte 20, Bit 5
Values:
1: SRA available
0: SRA does not exist
4. Indicator Soft Touch
Sets the number of flash operations of soft touch turn signals
Control unit “09-Central Electric”>> “Adjustments”>> “Comfort turn signal (Cycles)
Adjustable: 1-5x
Default value: 3 times
5. Disable DRL Dimming When Indicating
Disables the dimming (25%) of the LED daytime running lights flashing as the light level.
Control unit “09-Central Electric”>> “Encoding”>> Byte 15, Bit 3
Values:
1: Dimming active (default)
0: disable dimming.
6. Coming & Leaving Home light Cycle
Setting the operating time of coming and leaving home function.
Control unit “09-Central Electric”>> “Adjustments”>> “Coming Home-Time” and “Leaving Home-Time”
Possible burn times up to 60 seconds.
Default values:
Coming Home Time: 15 sec
Leaving-Home Time: 60sec
7. Needle Swoosh
(VCDS) staging = pointer when you start
`Address 17: go control panel insert> Customize> production and> active”
Ignition off and on again to finish
8. Seat Belt Warning Disable / Modify
Disables the seat belt reminders
Control unit “17-panel insert”>> “Adjustments” Disable Seatbelt>>
Adjustable: yes / no
Default value: no
9. Changes the seat belt warning
Control unit “17-panel insert”>> “Adjustments”>> “Seatbelt”
Adjustable Version 2 (normal) / Variant 3 (subjectively more aggressive)
Default value: Variant 2
10. Activate Rear LED Lights as DRLs (Xenons Only)
The green indicator light on the light switch stays lit all the time. Also the map display in navigation mode is
dimmed for night usage all the time.
Control unit “09-Central Electric”>> “Encoding”>> Byte 18, Function 7, Change code 72 to 73 in long code
Values:
Bit 0 Enable.
11. Deactivate Auto Rear Wiper on Reverse
Control unit “09-Central Electric”>> “Encoding”>> Byte 21, Bit 6
12. Mirror Dipping on Reverse Active
Control unit “Door Elec Passenger”>> “Encoding”>> Byte 4, Bit 2 and Bit 3
13. Hill Hold Assist
Controller 03(ABS)
Coding 07
long code helper
Byte 16
Bit 0 enable (tick box)
14. Siren Alarm Type
Control unit “09-Central Electric”>> “Encoding”>> Byte 6, Bit 1